Post Number: 64
|Posted on Monday, March 17, 2008 - 10:23 am: ||
I have a slight issue with my Voyage VR9000 in the mobile.
I had it in my base with a 2 pill fatboy, no problem.
I hook it up in my mobile it was fine.
Soon after it started to get alternator whine.
I play with the power connector it goes away.
Now its there for good.
Again in the base its fine.
I put my 2 pill amp in the mobile and when I key the voyage I just get a horrible squeal from it.
I hooked my 2950 in the mobile and it sounds cherry.
Does anyone know what the problem may be?
813 Rhode Island
Fatboy 2 Pill @ 15vdc
Post Number: 1332
|Posted on Monday, March 17, 2008 - 7:38 pm: ||
are ya using talkback with voyage?if so turn it off
Post Number: 42
|Posted on Friday, August 01, 2008 - 9:21 am: ||
i to have squeling some times i think that its because of the no mike gain.mine will squell when i touch the body of my jeep,ive grounded everything good and i still cant stop it,also a regular stock mike wont work eather it will squeal there good radios but they like to squeal.
Post Number: 2560
|Posted on Friday, August 01, 2008 - 10:20 am: ||
Do you run the power wires direct to the battery? Sometimes you can run the negative cable to the chassis and that will help. Just remember to use the shortest possible wires you can.
The amp will need well grounded with the shortest possible power cables, neg to chassis and of course a very low swr is important. good luck
KEEP IT REAL!
Post Number: 43
|Posted on Friday, October 01, 2010 - 11:18 am: ||
do you think that the modulataion is tuned to loud? copper tuned so i dont know how high they went.it evens squeals with a stock voyage mic.still squealing when i touch the side of the jeep.i talked to a guy in fl. and he has the same rig and set up i do and his does the same thing.any ideas ill try anything at this point
Post Number: 116
|Posted on Tuesday, October 19, 2010 - 6:25 pm: ||
if you look up the mod on this radio here on this site it tells you what to do there is a chock (big one)right behind the mic. plug on the board is where it is & tells you to move or pry it away from the plug its the only big one on the board to stop the rf feed back
Post Number: 44
|Posted on Sunday, November 07, 2010 - 11:43 am: ||
thank you so much that was about to drive me crazy i cant even run a stock mike on it not even the mike that comes with it